Innokin iTaste VTR - Page 6

3
4
5
To switch the iTaste VTR between Variable Voltage mode and Variable Waage mode you press the
“funcon key” for one second to display the Ohm reading of the aached atomizer or clearomizer.
While this the Ohm reading is displayed, press and hold the “Funcon key” again ll the display
shows that you have changed either from Voltage to Waage or vice versa.
Rotaonal Wheel can be rotated clockwise (+) and counterclockwise(-) to adjust the voltage or
waage.
Rotaonal Wheel can be rotated clockwise (+) and counterclockwise(-) to adjust the voltage or
waage.
Quickly clicking it three mes will enable or disable the baery. Once enabled, holding down the
buon will acvate the baery.
This safety feature prevents the atomizer from turning on while it's in your pocket or bag and it
prevents any sengs from geng changed without your knowledge.
“ ” buon: ON/OFF baery switch.
ON Mode
Quickly clicking the “ ” buon three mes will turn the iTaste VTR on; your LED light will blink from
red to yellow to green; and the LCD will display “ON”. Once turned on, holding down the “ ” buon
will fire the device.
OFF Mode
Quickly clicking “ ” buon three mes turns the device off. The digit screen will show “OFF” to
confirm that your device is in the off mode.
Baery Capacity Display
The LED lights will show green, yellow or red to indicate whether there is full baery life, half capacity
or charging needed.
There are three main buons on the iTaste VTR: The “ ” buon, “rotaonal wheel” and "funcon
key" which is located in the center of the rotaonal wheel ; all the funcons can be acvated by using
those three buons to change sengs in one step, your chosen mode will be displayed on the digital
screen.
Funcon key buon : Acvates the Resisve Load Detecon ( Ohms meter ) and shows the last
7/EN-7 8/EN-8