Innokin KROMA-A ZENITH Kit - Quick Start Guide; Initial Setup and Operation; Tank Filling and Coil Saturation

13
12
QUICKSTART GUIDE
●
Attach & Fill the Innokin Zenith Tank.
●
Power on the Innokin Kroma-A. [3x Power]
●
Press [+] 4x to Select [W] Wattage Mode. Press [Power] to Select.
●
Hold the [+] Button until the Wattage Flashes.
●
Use [+] – [-] Button to set Wattage.
Check Coil for Resistance(Ω)and Wattage Range.
●
Start low and increase wattage to preferred heat and flavor.
Do not exceed recommended Wattage or the coil may be damaged.
●
Adjust Zenith Tank Airflow to your preferred draw.
●
Press the Power Button to Vape & Enjoy!
*Power Off the Innokin Kroma-A when not in use.
Read the Battery Safety Guide for important information.
If you have any questions please write to support@innokin.com.
ATTACH TANK
1
UNSCREW CAP AND TOP FILL
PLEASE WAIT 5 MINUTES FOR COIL TO SATURATE
2
3X CLICKS
TO TURN ON
WATTAGE COIL
TEMP.COIL
SELECT COIL
COIL TYPE 0.21Ω
SAME Ni Ti SS W
3
4
RESISTANCE
ADJUST SETTINGS
AS DESIRED
VAPE & ENJOY!
BATT.LIFE
VOLTAGE
WATTAGE
PUFF TIME
WATTAGE
TEMP.CONTROL
WATTAGE TEMP.(C OR F)
RESISTANCE,WIRE TYPE
5
6