EasyManua.ls Logo

Innotek HF-025E User Manual

Innotek HF-025E
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Containment System
Operation Guide
This Innotek® electronic dog collar is among the safest, most
humane and effective training products you can buy. Used prop-
erly, the collar's electronic stimulus serves as a distraction that
your dog will find undesirable. By obeying, your dog quickly learns
to shut off the stimulus, thus gaining confidence in response to
your commands. Like most Innotek training products, this collar
has adjustable stimulation levels. This feature allows you to use
the level that best matches your dog's temperament.
CAUTION
Please take a few minutes to read the instruction manual prior to your first use. This instruction manual contains
important programming and set-up information to help your training proceed as successfully as possible. For best
results, follow these important rules:
The electronic dog collar is intended only for use on dogs.
Most dog owners are surprised at how much can be accomplished by using low-level stimulation;
therefore, use the lowest stimulation necessary to get the desired behavior.
A low battery may cause intermittent operation. DO NOT USE if you suspect a low battery.
Allow your dog to get used to the collar before you begin training. You want your dog to accept the
collar as part of a routine, not to associate the collar with correction.
DO NOT leave the collar on your dog for more than 12 hours per day.
NEVER perform set-up procedures when the collar is on your dog.
An electronic collar should only be used under close supervision by the dog's owner.
KEEP OUT OF THE REACH OF CHILDREN.
Read all instructions before using this product. If you have questions or concerns, contact your
nearest INNOTEK dealer or service center.
IMPORTANT
Realize that because individual dogs have unique temperaments, there is no way of knowing how your dog will
react to its introduction to this product. For the safety of your dog, initial training should take place using a long
leash to keep you in control of the situation. Also realize that an aggressive animal could turn against the handler
upon receiving the stimulus. Therefore, if you feel your dog has an aggressive behavior and/or it has a history of
aggressive behavior, you should consult a certified animal behaviorist before using this product. Please refer to the
Training Your Dog, Section 3 on Page 9.
HOW IT WORKS
The boundary wire is connected to the wall transmitter powered by an AC adapter.When the containment system
is turned on, a radio signal is transmitted through the wire. If a dog wearing the collar receiver approaches the
wire, the signal causes the collar receiver to deliver a brief, harmless correction. The dog naturally seeks to avoid
the wire and thus quickly learns to stay within the established boundaries.
1
Ne Onzichtbare omheining 15
Fr Guide d’emploi 30
De Bedienungsanleitung 45
It Guida di funzionamento 60
Es Guia de Funcionamiento 75
Question and Answer IconNeed help?

Do you have a question about the Innotek HF-025E and is the answer not in the manual?

Innotek HF-025E Specifications

General IconGeneral
BrandInnotek
ModelHF-025E
CategoryPet Care Product
LanguageEnglish

Summary

System Setup: Area Preparation and Transmitter Location

System Setup: Wire Estimation and Transmitter Configuration

Install and Configure Wall Transmitter

Install the transmitter near an outlet and set the yard size jumper for optimal performance.

System Setup: Wire Connection and Verification

Collar Receiver Specific Setup

Charge Rechargeable Collar Receiver

Charge rechargeable collar for at least 12 hours before first use; system won't function while charging.

Install Battery in Operated Collar Receiver

Unscrew cap, insert 6-volt battery with positive side up, and replace cap securely.

System Testing and Signal Field Adjustment

Test Containment System Signal

Use the test light to verify signal transmission through the wire without the collar on the dog.

Adjust Signal Field Width

Use the Field Width knob to set the signal field size, ensuring it extends appropriately around the wire.

Dog Training Procedures

Troubleshooting System Issues

Address Dog Not Responding to Correction

Check collar fit, probe contact, battery, and transmitter jumper settings for response issues.

Perform System Test Loop

Use a test loop and test light to diagnose malfunctions in the collar, transmitter, or yard wire.

Troubleshooting Wire Breaks

Locate Wire Breaks

Use an RF-Choke and portable radio to identify breaks or nicks in the boundary wire.

Related product manuals