4
SAFETY PRECAUTIONS / WARNINGS
Safety First!
SAFETY PRECAUTIONS / WARNINGS
SAFETY FIRST!
This tester has been designed, manufactured and tested to comply
with IEC61010-1, CAT III 600V and CA65 Rules. The LICENSEE
and END USER shall be made aware that, if the tester is used
in a manner not specifi ed by the manufacturer, the protection
provided by the equipment may be impaired.
Before using the tester and probe, please make
sure the tester and the test lead are in good
condition. DO NOT use the tester if you fi nd any
damage to the tester and/or the lead, including a
broken tester housing, damaged insulation layer
of the test lead, no display or a malfunctioning
display screen. To avoid electric shock, DO NOT
use the tester without proper installation of battery
compartment cover.
DO NOT use damaged test lead. Use a good test
lead that meets the same electric standards.
When using the tester, DO NOT touch the
uninsulated electric wires, connectors, ends of the
test probes and circuits.
Measure with extreme care for AC voltage higher
than 30V. To avoid electric shock, keep fi ngers
behind the probe sheath.
DO NOT apply more than the rated voltage, as
marked on the tester, between the COM terminal
and the input terminal.
Make sure correct function is selected before
starting any test. Before shifting to another test,
make sure the test leads are disconnected from
all circuits.
To avoid damage to the tester, DO NOT shift
functions during test.
To avoid electrical shock and/or damage to the
circuit tester, ensure the power is removed from the
circuit before any resistance, diode or continuity
testing procedure is conducted, and discharge
all capacitors. Always test resistance, diodes and
To Next Page
Loading...
