Pure IP-Telephony
Page - 1 -
Errors and omissions excepted. All information, technical specifications, and delivery times may be subject to change.
ts_IP110_en.doc, Issue: August 2008
Copyright © 2004-2008 innovaphone
®
AG
Technical Specification
IP phone IP110
Interfaces
Ethernet:
2 x RJ 45 interface
10/100-BASE-TX (auto negotiation)
with internal 2 port switch
and Power over LAN, Class 1 (IEEE 802.3af)
Hardware
Power supply: Power over LAN, Class 1 or
Mains adapter
primary: 110-240 V, 50 Hz, 45mA,
secondary: 12V DC 800mA,
Memory: 8 MB DRAM
4 MB Flash
Operation environment: Operation temperature: 0°C to +45°C,
Humidity: 10% to 90% non-condensing
Storage temperature: -10°C to +70°C
Display: 128 x 64 Pixel - or - 7 lines with 21 characters
Keyboards: numeric,
2 arrow keys,
4 free programmable function keys
volume and free speech keys
Protocols
DHCP dynamic host configuration protocol - IP interfaces settings
ICMP Internet control message protocol - for Ping tests
SNTP simple network time protocol – to receive date and time values
LDAP lightweight directory access protocol – access for LDAP compatible database
PPPoE PPP over Ethernet – direct access to DSL modem
PPTP point-to-point tunneling protocol – to setup VPN tunnels to the corporate network
MPPE Microsoft point-to-point encryption - encryption in PPTP
NAT network address translation – to translate official IP addresses in unofficial addresses and vice versa
(inclusive SIP und H.323)
HTTP for configuration sing Web browser
SNMP sending traps to the management software
To Next Page
