11-0138C
SCG-1
User Manual
Warning!
The Oxygen Sensor used in this device gets very hot in operation.
Do not touch a hot sensor. Do not let a hot sensor touch a combustible surface. Do not use the
sensor with or near flammable liquids or gases. Failure to heed these warnings may result in
severe burns, explosions, fires, or other dangerous events.
1. SCG-1 ...................................................................................................... 2
1.1 Changing the SCG-1’s gauge face and/or bezel ............................. 3
Installation ................................................................................................ 4
2
2.1 Wiring ............................................................................................... 4
2.1.1 Single Innovate Device Relay Wiring Instructions ....................... 5
2.2 Gauge Mounting and Routing ......................................................... 5
2.3 Solenoid Installation ........................................................................ 6
2.3.1 Internal Wastegate ...................................................................... 6
2.3.2 External Wastegate ..................................................................... 7
2.4 MAP sensor ..................................................................................... 7
2.5 Wideband Oxygen Sensor Setup .................................................... 7
2.5.1 Oxygen Sensor Placement .......................................................... 7
2.5.2 Sensor Calibration ....................................................................... 9
2.5.3 Calibration Schedule ................................................................. 10
Boost Controller Setup ........................................................................... 10
3
3.1 Entering Setup Configuration ........................................................ 10
3.1.1 Configuration using SCG-1’s interface buttons ......................... 10
3.1.2 Configuration using the LM Programmer software .................... 10
3.2 Display Settings (Gauge Abbreviations) ........................................ 11
3.3 RPM Settings (Gauge Abbreviations) ........................................... 11
3.4 Solenoid Settings (Gauge Abbreviations) ..................................... 11
Logworks 3 & LM Programmer Software Package ................................ 13
4
4.1 Download and Install the Logworks 3 Software ............................ 13
4.2 LM Programmer ............................................................................. 13
4.2.1 Programming Analog Output ..................................................... 14
4.2.2 Advanced Analog Output Programming .................................... 14
4.2.3 Updating the Firmware .............................................................. 15
4.2.4 Changing Sensor Type .............................................................. 15
4.3 Logging data from your SCG-1 with LogWorks ............................. 16
Appendix A: Limited Warranty ....................................................................... 17
Appendix B: SCG-1 Error Codes and Troubleshooting Tips ......................... 18
To Next Page
Need help?
General
