Innovative Technology ITVS-1350 - Repeat; Programming Function; Repeat Play; Programmed Play

8
REPEAT / PROGRAMMING FUNCTION
REPEAT PLAY:
-Press the REPEAT button to step through the available repeat modes – REPEAT 1, REPEAT ALL or OFF.
REPEAT 1: Continuously repeat the current track, the repeat indicator will flash.
REPEAT ALL: Repeat the entire disc continuously, the repeat indicator will remain lit.
When REPEAT is OFF: Repeat indicator will not be illuminated.
NOTE: When the CD is stopped, the repeat modes will be cleared.
PROGRAMMED PLAY:
While the disc is stopped, you can store a programmed selection from the disc in your preferred
sequence.
TO SET A PROGRAM:
1. Press STOP button to stop the CD from playing.
2. Press PROGRAM button.
-LED indicator will light up and the ‘01’ will start flashing on the display indicating the position
of the track in the program.
3. Select a track you want to program by pressing the FAST FORWARD or REWIND button.
4. To save this track into the program sequence, press the PROGRAM button again.
‘02’ will start flashing on the display indicating the second track in the program.
5. Repeat step 3 and 4 until you have stored all the tracks in the program sequence.
NOTE: During program setting, DO NOT press the STOP button unless you want to reset the
programming from the beginning.
PLAYING THE PROGRAMMED SELECTION:
Press the PLAY/PAUSE button to start playing the program.
SELECTING TRACKS:
You can navigate through the tracks stored in the program by pressing the FAST FORWARD or
REWIND button.
-Press the FAST FORWARD button once to go to the start of the next track.
-Press the REWIND button once to go back to the start of the previous track.
TO CLEAR THE SET PROGRAM:
Press the STOP button to stop the programmed playlist.
Press the STOP button again to clear the program. LED indicator will not illuminate.
REPEAT MODES:
Repeat modes may be selected when a program is playing.