Data Entry Monitor Arm
Model No. 9047/9071
INSTRUCTIONS
The IOP Monitor Arm Model 9047/9071 comes in four parts.
Each component is sold separately.
1. Mount assembly (instructions enclosed separately)
2. Monitor Arm assembly
3. Monitor Platform (instructions enclosed separately)
4. Keyboard Assembly (instructions enclosed separately)
The Monitor Arm is easily assembled following these three simple
steps.
Be sure the mount is securely fastened to the surface before begin-
ning.
Ste
p 1 Attaching the arm to the mount
Insert the shaft of the Arm assembly into the mount as shown below in
Illustration 1 (Mounts will vary).
Illustration 1
Step 2 Attaching the Monitor Platform
After the Monitor Platform has been removed from wrap; unscrew
the (4) four 1/4” x 20 Philips flat head screws from the non-tilt base
(found in the center post).
Place the platform on top of the non-tilt base, line up the screw hole
pattern and replace the screws and tighten.
See Illustration 2.
Non-Tilt Base
Center Post
Illustration 2
Ste
p 3
Attac
hing the Keyboard Platform
Insert the shaft of the Keyboard Assembly into the arm. See
Illustration 3.
Illustration 3
Fine Tuning Your Arm
Now that you have assembled your Data Entry Monitor Arm, you are
now ready to begin fine tuning the components. Follow these 3 simple
steps to get accurate resistance or change resistances.
Ste
p 1 Setting the Counter-balance
Place your monitor on the platform before adjusting the counter-balance.
Use the 1/4” allen wrench (provided), insert into the hole on the top of
the end cap as shown in Illustration 4.
Turn left (counter clockwise)
for heavier weight
End Cap
Turn right
(clockwise) for
lighter weights
Illustration 4
IMPORTANT:
With one hand, hold the arm in a horizontal position, while turning the
allen wrench with the other hand to make the weight adjustment.
To increase the weight for heavier monitors, turn the wrench left
(counter clockwise). To decrease the resistance for lighter monitors,
turn the wrench to the right (clockwise).
Tip:
The counter-balance weight adjustment can be
adjusted to favor a slight lifting or lowering of the
monitor’s weight. Most users prefer operating their
computer in a sitting position and find it easier to
pull the monitor down toward them. Assistance
may be required when lifting the monitor up and
out of the way.
Keyboard
Assembly
To Next Page
Need help?
General
