21
DISPLAY MODES
• CRUISE CONTROL (third mode)
The default setting is Cruise Control off (letter "n" to indicate).
Press or to choose enable Cruise Control
(Letter "Y" to indicate).
Long touch to save setting.
Short touch to enter forth mode.
SET KM OR MILE(forth mode)
The default setting is km/h(letter “0” to indicate).
Press + or - to change to km or mile(letter “1” indicate mile).
Long touch to save setting.
The default setting is photocell on(letter “Y” to indicate).
Press + or - to choose disable photocell(letter “n” to indicate).
sserp ,”Y“ si rettel nehW
value is 510. Press +/- to turn up/down the value. After saving setting, the
front & rear LED lights will turn on automatically if the ambient photographic
is lower than set value. Otherwise the lights will be off.
Long touch to save setting.
Short touch
• TRIP RESET
Reset TRIP by long press
OTHER DISPLAY MODES ARE:
• TRIP- your trip distance since your last trip reset. Press to swap.
• ODO - your scooter total distance since its factory assembled,
or new / repaired battery was placed.
• Battery voltage - Your battery state.
• Error - your system has encountered an error, please contact your local
To Next Page
Loading...
