AMTEK Version 7.4 2019-01 Page 21 ©Inomatic 2017-2019
3.3. Installation Procedure
Remove base covers from pedestal.
Electronics will now be visible. Confirm all connections are firmly in place.
Place Processor / RX pedestal in the place to be installed.
Consider the position of AC 230V/50Hz power source. Ensure that 230V 50Hz AC
source can be connected with the Power Supply and that the Power Supply output
cable can be connected with the Processor pedestal.
It is strongly recommended to tune the system to its final working conditions
BEFORE drilling any hole!
Avoid placing the Processor pedestal very near metallic structures (doors, frames,
etc...) or neon/discharge lamps and LED, LCD monitors.
In case of Dual or Split system connect RX pedestal(s) to Processor TX
pedestal using the connection cable AMCTR 710
Confirm all connections to the loops, and processor board are firmly in place.
Before turning the Processor antenna (TX or Mono) on, remove all 58 kHz
tags near to it.
Connect Power Supply to the Processor board with the 2-pin and 3-pin
connectors
Connect Power Supply to AC 230V/50Hz source, switch on the power supply.
Connect the computer via the LAN cable and start
InfoNet V5 software (for tuning please refer to the InfoNet manual)
To Next Page
Loading...
