Need help?Do you have a question about the InoTec CLS 24.1-7Ah and is the answer not in the manual?
General| Brand | InoTec |
|---|---|
| Model | CLS 24.1-7Ah |
| Category | Lighting Equipment |
| Language | English |
Explains symbols used in the manual for safety and important information.
Outlines INOTEC's warranty limitations and liability exclusions.
Specifies that only original INOTEC spare parts must be used for replacement.
Provides guidance on how to dispose of batteries and electronic components.
Details the procedure to reset fault indications after fixing issues.
Emphasizes reading instructions for safety, usage, and maintenance.
States that repairs must only be performed by authorized INOTEC personnel.
Instructs to check the device for damage and completeness upon receipt.
Provides guidelines for storing the device to maintain its condition.
Describes the physical layout and components of the CLS system.
Lists technical specifications for the CLS 24.1 - 7Ah model.
Lists technical specifications for the CLS 24.1 model.
Lists technical specifications for the CLS 24.1 - Power model.
Explains how to unpack and access the device components.
Details the procedure for checking and connecting batteries.
Describes how to connect the 230V AC power supply to the device.
Explains the system's 4 final circuits for monitoring luminaires.
Describes how to switch general and safety luminaires together.
Explains the function and connection of the 24V current loop for safety.
Describes connecting multiple CLS devices to a central mimic panel.
Explains connecting an external remote mimic panel to the device terminals.
Details how to use the InoWeb module for network monitoring.
Explains how to use the CLS dimmer module for central luminaire dimming.
Provides the correct sequence for powering down the CLS device.
Provides the correct sequence for powering up the CLS device.
Lists the default configuration parameters of the controller.
Describes the system's protection against unauthorized operation.
Outlines the navigation and organization of the CLS system's menu.
Describes how to access and perform various tests on the system.
Explains how to configure the CLS system settings.
Explains how to access device and luminaire status information.
Describes how to release a blocked CLS device.
Details how to identify and resolve luminaire failures.
Explains how to check for and resolve battery circuit faults.
Describes the message displayed for a main distribution board power failure.
Describes the message displayed for a sub-distribution board power failure.
Explains how to access and use the InoWeb interface.
Describes how to print fault information from the web browser.
Explains how to configure automatic email notifications for system events.
Describes the process of programming the InoWeb module via serial interface.
Outlines the initial tests required after system setup and installation.
Details recurring tests required by national guidelines.
Provides a template for documenting the system configuration.
To Next Page
