What to do if the INOXPA Hyclean Water Pump suction pipe is clogged?
If the suction pipe of your INOXPA Water Pump is clogged, you should check the suction pipe and filter(s), if any, to resolve the issue.
How to fix an INOXPA Hyclean Water Pump that sucks in air?
If your INOXPA Water Pump is sucking in air, check the suction pipe and all its connections to ensure they are properly sealed.
How to resolve motor overload in an INOXPA Water Pump?
To resolve motor overload in your INOXPA Water Pump, invert the rotation direction.
What to do if INOXPA Hyclean Water Pump is not purged?
If your INOXPA Water Pump is not purged, you should purge or fill it to resolve the issue.
How to manage high liquid viscosity in INOXPA Water Pump?
If the viscosity of the liquid is too high in your INOXPA Water Pump, you can reduce the viscosity by, for example, heating the liquid, or reduce the pump speed.
How to manage low liquid viscosity in INOXPA Hyclean Water Pump?
If the viscosity of the liquid is too low in your INOXPA Water Pump, increase the viscosity by, for example, by cooling the liquid, or increase the pump speed.
How to reduce high liquid temperature in INOXPA Hyclean?
If the temperature of the liquid is too high in your INOXPA Water Pump, reduce the temperature by cooling the liquid.
What to do if the lobes are worn in INOXPA Hyclean?
If the lobes are worn in your INOXPA Water Pump, replace the lobes.
General| Surface Finish | Ra ≤ 0.8 μm |
|---|---|
| Applications | Food-processing, cosmetics, pharmaceutical and fine chemical industries |
| Pump Type | Centrifugal |
| Impeller Type | Open impeller |
| Material | Stainless steel AISI 316L |
| Maximum Head | 70 m |
| Maximum Working Pressure | 10 bar |
| Maximum Temperature | 120 °C |
| Seal Type | Single mechanical seal |
| Certifications | EHEDG certified |
| Hygienic Design | Yes, EHEDG certified |
To Next Page
