Insignia 800 - Steam Generator Connections

www.insigniashowers.com Last Modied 09/07/2021
21
The steam generator has 3 connecons.
1. Steam Outlet: Connect the white insulated hose to the steam system within your shower as shown in
image A. Make sure these are ed in the correct posion as they are only aached for
transportaon reasons only.
2. Water Inlet: When installing the water line for the steam generator, there are 2 opons available:
• Purchase Insignia’s WRAS approved braided hoses—dierent packs are available for dierent shower
types.
• Install a stac water line from the shower valve (middle feed) to the steam generator. Even with a stac
water line, exible hosing will sll be required for the hot and cold water feeds. If you choose this opon,
please ensure you purchase the correct hose pack from www.insigniashowers.com
3. Drain: Connect the grey rubber hose from the steam generators drain opening to the nozzle on the
shower waste as shown in image B. Secure in place with the use of the Jubilee clip (AMI01) found in
your screw pack Ensure you drill out the spigot to allow the steam generator water to drain in to the
waste.
Steam Generator Connections (steam version only)
NOTE: MUST DRILL OUT
2
1
3
White Insulated Pipe
Steam Outlet
A
B
Steam
Generator