Insignia 800 - Steam Room Usage Guide

www.insigniashowers.com Last Modied 09/07/2021
28
Steam Room Usage Guide
1. To use the steam room, turn the control panel on. (1)
2. Press the steam buon (2) and your generator will be fed with water and the heang
element will begin to heat the water to create steam. (You should be seeing steam from
your outlet in approximately 60-90 seconds)
3. To set the temperature you want the cabin to reach, press the funcon buon (3) once
the steam is acve. You will see a small °C to the right of the display. The large number in
the middle of the display can be changed by pressing the arrows (4). The maximum
temperature you can reach is 60°C . The average temperature in a steam room is usually
between approximately 30 to 36°C subject to bathroom ambient air temperature.
4. To set the length you wish the steam to run for, press the funcon buon again (3) then
use the arrows (4) to set your desired me. The maximum length that can be set is 60
minutes.
5. Only steam for approximately 10-15 minutes per session at your desired temperature.
Due to temperature, your body can overheat, dehydrate and cause light headedness. This
is very important for both your health and wellness.
6. Correct Procedure when using steam is SHOWER FIRST this will open your skins pores and
your shower cabin will be warm on use. Steaming without showering lowers benets and
not recommended. If you do so NEVER run your steam generaon before use to warm
the shower, this can cause damage to operang parts, isn’t safe pracce and will not
warm your cabin. NEVER Shower and Steam at the same me.
Before using the steam room, always read the steam room and shower safety guide rst.
1
2
3
4
4