GB 22
Automatic tuning
1. Press TUNER to select tuner mode.
2. After two seconds the display will change to show the current band and frequency.
3. If necessary, press TUNER again to switch between AM and FM band.
4. Press and hold or for more than one second to activate auto tuning mode. When a
station is reached, auto tuning will stop.
Note: Press “Pause” button on the Front Panel can toggle between the frequency tune up & down and preset
channel up & down.
Tuning to a weak FM stations
1. Press to tune in a weak FM station manually.
2. Press AUDIO/FM ST on the remote control to switch to Mono mode. This will reduce the background
noise and make the station easier to listen.
Preset Stations
When a preset station is selected, the preset number will appear next to the frequency on the display.
Selecting Preset Stations
1. In tuner mode, press TUNER to switch between AM and FM band if necessary.
2. Press OK, then use / on the Front Panel or the remote’s numeric keys or to select
desired preset station.
Storing Preset Stations
The unit can store up to 20 stations in the FM and AM wavebands respectively.
1. In tuner mode, press TUNER to switch between AM and FM band.
2. Press to tune in the desired station.
3. Press OK until the preset channel icon flashes.
4. Press or use the remote’s numeric keys to select the preset channel number .
MHz
MHz
MHz
MHz
HzM
To Next Page
Loading...
