Insignia NS-BK2TSS6 - Page 15

15
Insignia Single- and Dual-Tap Kegerator/Beverage Cooler
www.insigniaproducts.com
Single-tap model:
1 Feed a hose clamp over the end of the CO
2
gas line.
2 Attach that end to the gas line connector on the CO
2
regulator.
3 Tighten the clamp to prevent leaks. Leave about ½ inch between the
top of the clamp and the end of the hose. You may need to squeeze
with a pliers or crimper.
4 Attach the CO
2
regulator to the CO
2
tank by screwing the regulator nut
onto the CO
2
tank valve and tightening with an adjustable wrench.
Dual-tap model:
1 Feed a hose clamp over one end of the CO
2
gas line that does not have
a connector on either end.
2 Attach that end to the gas line connector on the CO
2
regulator.
3 Tighten the clamp to prevent leaks. Leave about ½ inch between the
top of the clamp and the end of the hose. You may need to squeeze
with a pliers or crimper.
4 Feed a hose clamp over the other end of the CO
2
gas line.
5 Insert the T-connector into the end of the gas line, then tighten the
hose clamp. Leave about ½ inch between the top of the clamp and the
end of the hose.
CO
2
regulator
CO
2
tank
Regulator nut
Tank valve
Hose clamp
Gas line connector
Hose clamp
T-connector
CO
2
gas lines
Dual-tap model
Hose clamp
Hose clamp
CO
2
gas
line
CO
2
gauge
NS-BK1TSS6_NS-BK2TSS6_15-0765_MAN_V3_ENG.fm Page 15 Tuesday, December 22, 2015 6:20 PM