20
Insignia Single- and Dual-Tap Kegerator/Beverage Cooler
www.insigniaproducts.com
4 Open faucet handle quickly and completely and fill the glass to 2/3
full.
5 Level the glass and finish topping it off by pouring into the center of
the glass.
6 Fully close the tap when the draw is complete.
Automatic defrosting
There is no need to defrost your kegerator/beverage cooler. The defrost
water collects at the back of your cooler and passes through a drain outlet
into a tray located above the compressor where it evaporates.
Maintaining your kegerator/beverage
cooler
Your kegerator/beverage cooler is designed for year-round use with only
minimal cleaning and maintenance.
When you first receive it, wipe the case with a mild detergent and warm
water, then wipe dry with a dry cloth. Do this periodically to keep your
kegerator/beverage cooler looking new.
Cleaning the interior of your kegerator/beverage cooler:
1 Turn off the kegerator/beverage cooler and unplug it from the wall
outlet.
2 Remove all kegs and beverages.
3 Wash the inside with a damp warm cloth soaked in a solution of one
quart of lukewarm water to two tablespoons of baking soda solution.
4 Wash the shelves and metal plate with a mild detergent solution.
5 Wring excess water out of the sponge or cloth when cleaning around
the controls or any electrical parts.
6 Wash the outside cabinet with warm water and mild liquid detergent.
Rinse well and wipe dry with a clean soft cloth.
7 Be sure to keep the door gasket (seal) clean to keep the unit running
efficiently.
8 Dry the interior and exterior with a soft cloth.
Caution
To prevent damage to the finish, do not use:
• Gasoline, benzine, thinner, or other similar solvents.
• Abrasive cleaners.
NS-BK1TSS6_NS-BK2TSS6_15-0765_MAN_V3_ENG.fm Page 20 Tuesday, December 22, 2015 6:20 PM
To Next Page
Loading...