Insignia NS-FANT12-CH User Manual

Safety
screw
Front guard Rear guard
Blade
cap
Guard knob
Fan blade
Handle
Oscillation
knob
Lock
Fan blade
stem
Tilt knob
Stand
Motor housing
(assembled)
Power knob
Power cord
Base
Pole locking cap
Motor shaft
Blade cap Guard knob
Fan blade Rear guard
Motor housing (assembled)
Base
Pole locking cap
Front guard
Safety screw
Quick Setup Guide
Fan blade
stem
Quick Setup Guide
12" Table Fan
|
NS-FANT12-CH
Before using your new product, please read these instructions to prevent any damage.
Part callouts
Assembling your fan
1 Remove the pole locking cap from the stand, then remove the blade
cap and guard knob from the motor shaft.
2 Slide the stand into the hole at the center of the base, then tighten
the pole locking cap underneath the base.
Package contents
12" table fan includes:
Features
• Four metal blades
• Oscillating head with adjustable angle tilt
• 3-speed settings
• Fused safety plug
3 Slide the back guard onto the motor shaft, then screw the guard knob
on to hold it in place. Make sure that the handle is at the top.
4 Put the fan blade on the motor shaft, then screw the blade cap on to
hold it in place. Make sure that the stem of the fan blade is closest to
the motor housing.
5 Align the screw holes in the front and back guards with each other,
then close the four locks to hold the guards together.
Tip: The screw holes are at the bottom of the guards.

Insignia NS-FANT12-CH Specifications

General

Brand	Insignia
Model	NS-FANT12-CH
Category	Fan
Language	English

Summary

Assembling Your Fan

Prepare Motor Shaft

Remove locking cap, blade cap, and guard knob from motor shaft.

Attach Stand to Base

Slide stand into base and tighten pole locking cap underneath.

Install Back Guard

Slide back guard onto motor shaft and secure with guard knob.

Mount Fan Blade

Place fan blade on motor shaft and secure with blade cap.

Secure Fan Guards

Align front and back guards, then secure with locks.

Fasten with Safety Screw

Insert and tighten safety screw into screw holes.

Using Your Fan

Speed Selection

Plug in fan and turn power knob to choose speed.

Oscillation Control

Push knob down for oscillation, pull up to stop.

Adjusting Tilt Angle

Loosen tilt knob to adjust fan angle, then tighten to secure.

Replacing the Fuse

Important Safety Instructions

General Safety Warnings

Read and save instructions; warnings about shock, misuse, children, location, and materials.