www.insigniaproducts.com
31
NS-HF2007
STEP 24:
You need:
When you insert a cam lock, position the open end of the lock toward the cam screw, then insert the cam screw into the
cam lock opening.
1 Insert two cam locks (DD) into the inside top edges of the left side (K), the right side (K), and the left top side of the
small divider (Y).
2 Lay the top (G) onto the left and right sides. Make sure that the cam screws fit into the cam locks,
3 Tighten all cam locks with a Phillips screwdriver.
DD Cam lock (6)
Phillips screwdriver
DD
DD
DD
DD
DD
DD
To Next Page
Loading...
