www.insigniaproducts.com
9
3-in-1 TV Stand
STEP 2: Attach the top shelf support to the top panel and spine
You need:
1 Align the top shelf support (G) with the center of the top shelf frame (A).
2 Place a flat washer (R), then a lock washer (Q) over the hole in the top of the shelf support and in the two holes on the
bottom of the shelf support.
3 Insert a 5/8" bolt (M) through each sets of washers, then tighten the bolts with the 4 mm hex key (W).
G Top shelf support (1)
M 5/8" bolt (3)
W 4 mm hex key (1)
Q Lock washer (3)
R Flat washer (3)
To Next Page
Loading...
