www.insigniaproducts.com
10
STEP 3: Attach the middle shelf to the spine
You need:
1 Place flat washers (R), then lock washers (Q) over the two drilled holes on the middle shelf (B).
2 Insert 1 1/4" bolts (O) through the washers and into the two threaded holes in the middle of the spine (F). Tighten the
bolts with the 4 mm hex key (W).
Note: The metal frame faces the floor when you turn your stand upright.
W 4 mm hex key (1)
Q Lock washer (2)
R Flat washer (2)
O 1 1/4" bolt (2)
B Middle shelf (1)
To Next Page
Loading...
