8
Insignia Metal Ceramic Heater
www.insigniaproducts.com
3 Plug the heater into the power outlet and then turn it on. The heater
resumes its normal operation.
Troubleshooting
Note
This heater includes a safety tip-over protection feature which
turns the heater off in case it is tipped over. If, at any time, the
heater does tip over, put the heater back in the upright position.
Caution
Do not try to repair your heater yourself. Doing so invalidates the
warranty.
Problem Possible cause Possible solution
Your heater shuts off
unexpectedly or fails to
operate
There is no power. Make sure that the heater is plugged in and that the
electrical outlet is working.
The set temperature is lower than
the current room temperature.
Set the desired temperature higher than the current
temperature to restart the heater.
Room temperature has reached the
temperature set on the temperature
control dial.
• This is normal. The heater restarts when room
temperature is lower than the set temperature.
• Adjust the temperature control dial setting if it's not
set to your desired temperature.
One of the safety protection devices
was activated to prevent
overheating.
1. Place the heater in an upright position.
2. Check for any obstructions. If you find an obstruction,
turn the heater off.
3. Unplug the heater and wait at least 10 minutes for it to
cool down.
4. Carefully remove the obstruction. Plug the heater in and
restart it as described in “Using your heater” on page 7.
5. If you still notice the same problem, remove the plug
from the wall and have the heater checked by an authorized
service person.
The room is not warm
enough
The room is too large or a window is
open.
• Turn on the main heat source for the room.
• Use more portable heaters.
•Close the window.
The temperature is set too low. • Increase the temperature setting.
The power setting is too low. • Select a higher power setting.
NS-HTMCSL6_15-0333_MAN_V2_ENG.fm Page 8 Wednesday, April 8, 2015 9:28 AM
To Next Page
Loading...
