8
Insignia Ceramic Tower Heater
www.insigniaproducts.com
3 Fit the base onto the bottom of the heater until it snaps into place.
4 Place the heater upright on a stable and level surface.
Using your heater
1 Make sure that neither the heater nor the power cord has been
damaged in any way during transportation.
2 Place the heater on a firm, level surface, at least three feet (0.9 m) away
from any wall or other objects such, as furniture, curtains, plants, or
combustible material.
3 Fully unwrap the power cord and plug it into a standard wall plug
(120 VAC~60 Hz).
4 Press the power button to turn the heater on. The display shows
the current room temperature in °F. The default temperature setting is
77° F and the heater is on low power with the low power indicator
turned on.
5 To change the settings when the heater is turned on, do the following:
Caution
Never leave an operating heater unattended.
To switch between low and
high power setting
• Press . The high or low power indicator turns on.
To turn on the ECO setting • Press . The ECO indicator turns on.
NOTE: In ECO mode the default temperature is 72°F. When the
temperature is below 64° F, the heater switches to high power. When the
temperature is between 64° and 72°F, the heater switches to low power.
When the temperature is above 72°F, the heater stops and displays the
room temperature.
NS-HTTCWH6_15-0380_MAN_V1_ENG.fm Page 8 Thursday, May 14, 2015 8:56 AM
To Next Page
Loading...
Need help?
General
