What to do if the Insignia NS-MGC300BN2 Massager air pump is overloaded?
If the air pump in your Insignia Massager is overloaded, unplug the power cord, wait 30 seconds, and then plug it back in.
What to do if the up and down movement is overtime in my Insignia Massager?
If the up and down movement of your Insignia Massager is overtime, ensure that your power supply is 110-120V ~ 60Hz. If the power supply is correct, try turning your chair off and then back on.
What to do if the massage hand up and down switch has malfunctioned in Insignia Massager?
If the massage hand up and down switch has malfunctioned on your Insignia Massager, first make sure that the travel switch wiring harness is connected correctly. If the wiring harness is properly connected, replace the travel switch.
What to do if the up and down motor is overloaded in Insignia NS-MGC300BN2 Massager?
If the up and down motor in your Insignia Massager is overloaded, make sure that the motor and gearbox aren’t damaged. If needed, replace the motor and gearbox.
What to do if the kneading motor is overloaded in Insignia Massager?
If the kneading motor in your Insignia Massager is overloaded, replace the kneading motor.
What to do if the up and down motor has malfunctioned in Insignia NS-MGC300BN2 Massager?
If the up and down motor has malfunctioned in your Insignia Massager, replace the up and down motor or the driver board.
What to do if the circle detection board has malfunctioned in Insignia Massager?
If the circle detection board has malfunctioned in your Insignia Massager, check that the relevant wiring harness is connected correctly. If the circle detection board isn’t receiving a signal, replace the board. The up and down motor or the driver board may also be bad, so replace the motor or board if necessary.
What to do if the tapping motor is overloaded in Insignia NS-MGC300BN2 Massager?
If the tapping motor is overloaded in your Insignia Massager, replace the tapping motor.
What to do if the Insignia Massager kneading motor can’t detect the kneading width?
If the kneading motor in your Insignia Massager can’t detect the kneading width, replace the width detection board.
What to do if the foot roller motor is overloaded in Insignia NS-MGC300BN2?
If the foot roller motor is overloaded in your Insignia Massager, replace the foot roller motor.
Details on grounding procedures to reduce the risk of electric shock.
Ensures the chair is connected to a properly grounded power outlet.
Procedure for the chair to scan and adapt to your body.
How to choose from preprogrammed massage programs.
Steps to personalize massage settings for the upper body.
How to control the chair's recline and leg rest.
To Next Page
General
