Cable
USB connector
VGA port
PACKAGE CONTENTS
• USB to VGA adapter
• Quick Setup Guide
SYSTEM REQUIREMENTS
• Windows® 10, Windows® 8.1, Windows® 8, or
Windows® 7
• Computer with a USB port
Note: A USB 3.0 port is recommended. The maximum
resolution for a USB 2.0 port is 800 × 600.
FEATURES
• Connects your desktop or laptop computer to a
VGA display
• Adds a VGA port to your computer
• Connects an extra monitor to extend your display
• Supports up to 1080p resolution (with USB 3.0 port)
• Works with legacy USB ports (maximum resolution
800 × 600)
Top view
Before using your new product, please read these instructions to prevent any damage.
INSTALLING THE DRIVER
To install drivers from the Internet:
1 Open your web browser and go to
www.insigniaproducts.com.
2 Type NS-PU96203 into the search box, then press
ENTER.
3 Click the SUPPORT/DOWLOADS tab.
4 Under Drivers, Firmware and Software, click English
next to “Windows 10 Driver.”
5 If using Chrome, click the downloaded file at the
bottom of your browser.
OR
If using Microsoft Edge, click Run.
6 Click Yes to allow the program to make changes, if
prompted.
7 Follow the Setup Wizard’s instructions, then click
Finish when installation is complete.
8 Restart your computer to configure the update.
Windows 10/Windows 8.1/Windows 8/Windows 7
1 Connect the adapter to a USB port on your
computer. Your computer attempts to install the
driver automatically.
2 If you’re using Windows 10, Windows 8.1 or
Windows 8, in the File Explorer, open This PC.
OR
If you’re using Windows 7, in the Windows Explorer,
open Computer.
3 Open the NS-PU96203&3C drive, then
double-click NS-PU96203&3C again.
4 Click Run or Yes to start the Setup Wizard.
5 Follow the Setup Wizard’s on-screen instructions to
install the drivers, then click Finish when
installation is complete.
6 Restart your computer to allow the changes to
take effect.
CONNECTING THE ADAPTER
• Connect the adapter to a USB port on your
computer, then connect a VGA cable (not
included) from the adapter to your display.
ADJUSTING YOUR SCREEN
RESOLUTION
Access display settings
Windows 10
1 Use the adapter to connect the display to your
computer. See “Connecting the adapter.”
2 Open Settings > System > Display > Advanced
display settings.
Windows 8.1/Windows 8
1 Use the adapter to connect the display to your
computer. See “Connecting the adapter.”
2 Open PC settings > PC and devices > Display.
Windows 7
1 Use the adapter to connect the display to your
computer. See “Connecting the adapter.”
2 Open Control Panel.
3 If viewing by icons, click Display, then click
Adjust resolution in the menu on the left.
OR
If viewing by category, under Appearance and
Personalization, click Adjust screen resolution.
USB to VGA adapter
VGA cable
(not included)
QUICK SETUP GUIDE
USB to VGA
Adapter
NS-PU96203 / NS-PU96203-C
Drivers, Firmware and Software
Windows 10 Driver: English
To Next Page
Need help?
General