Insignia Platinum Series - Final Checks and Sign-off; Leak Testing and Functionality; Finishing Touches

www.insigniashowers.com Last Modied: 17/05/2021
23
Now your shower is assembled, there is just few steps before you can sign the shower o.
1. Please ensure all the connecons are waterght including the waste, body jets, internal and external hoses
and steam connecons (model dependent).
2. Once you are happy, check the shower funcons by switching on the overhead shower and then adjust the
selector knob (top knob) to the hand shower and then onto the body jets. Whilst the water is running, check
external hoses for any signs or water drips or leaks and ghten accordingly.
Please note, when tesng the body jets, water will shoot towards the open doors and the user.
3. Do not aim the hand shower directly at the joints of your shower as this does not fall under “normal showering
condions”. However, due to Insignia’s unique design of the shower tray, water will only leak back in to the tray so you
won’t get ooded.
4. Visually check the water ow in to the waste and adjust the feet of the tray accordingly to ensure the direcon
of the water ows towards to the waste to prevent over puddling (a small amount of puddling is normal).
5. Never use the shower unl all checks have been made and the installer is 100% happy in the knowledge no hose leaks are
present.
6. Any RubberGum which has squeezed out between the panels and the tray, simply cut o using a sharp, clean knife blade.
7. Now push the shower from it’s base into it’s nal posion. NEVER PUSH THE GLASS OR FRAME into its nal resng
posion.
Happy Showering!
Signing off your shower