Pg. 10 V05032021
STEP 2
A. Install Guide Rods (#7) into holes on bottom Frame using M10 x 80 Allen Bolt (#18) and Ø 10 Spring Washers (#25).
Tighten bolts now.
B. Install Rubber Bumpers (#16) on each Guide Rod (#7). Slide fteen 10lb Weight Plates (#10) from the top of Guide
Rods (#7) down to the Rubber Bumpers (#16). Make sure the weight sticker cut out is facing the inside of the
machine.
C. Remove the two M10 x 19 Allen Bolts (#21), Ø 10 Spring Washers (#23), and Ø 10 Washers (#25) which were pre-
assembled in the factory to hold the Guide Rod Bracket (#6). Slide the Selector Stem Assembly (#8) onto the Guide
Rods (#7). Install Large Pulley (#30) and wrap the cable between the U-shaped Pulley Bracket (#27) using the M10 x 2
(#29) Allen Bolt located on the Selector Steam Assembly (#8).
D. Hold the Selector Stem Assembly (#8) above the weight stack to make it easier to install Guide Rod Bracket (#6) on
Guide Rods (#7).
E. Once the Guide Rod Bracket (#6) is installed onto the Guide Rods (#7), Push the Guide Rod Bracket back into the
upright.
F. Secure the Bracket back to the upright frame with the two M10 x 19 Allen Bolts (#21), Ø 10 lock Washers (#23), Ø
10mm Washers (#25).
G. Lower the Selector Stem down onto the top of the weight stack.
H. Check all the cables to make sure they are on track on the pulleys.
I. Peel o the weight resistance label from the Resistance Label Set (#26) and attach to the plates.
J. Insert the Weight Selector Pin (#9) into the weight stack.
K. Lubricate the Guide Rods with super lube or lube provided in Hardware Pack.
L. If Needed, Adjust the Cable tension by rst loosening the M10 x 2 (#29) Allen Bolt located on the Selector Steam
Assembly (#8) then rotate the Tension Adjustment Plate (#28) clock or counterclockwise to move the Bolt and the
Large Pulley (#30) up and down along the open track inside the U-shaped Pulley Bracket (#27). Once desired tension
is achieved, securely tighten the Bolt (#29) back.
M. Repeat the Procedure A through N above to install the other set of weight plates to the Left Station. (#2)
To Next Page
Loading...
