Pg. 10 V03042022
ASSEMBLY INSTRUCTIONS
STEP 1
A. Make sure any packing material or supports are removed from the frames prior to assembly. Start by placing the Right
Main Frame (6) in the vertical position. Having a second person to hold the frame is helpful or you can possibly lean the frame
against a wall. Insert two M10x75mm Hex Bolts (39) through the bottom Lower Crossbar (1) into the back of the Right Main
Frame (6), using M10 Flat Washers (43) on both sides and M10 Locknuts (42) hand tightened. Next insert two M10x90mm
Hex Bolts (40) into the side of the bottom Lower Crossbar (1) and Right Main Frame (6), using M10 Flat Washers (43) on
both sides and M10 Locknuts (42) hand tightened.
B. Place the Left Main Frame (5) in the vertical position and align it with the lower rear Lower Crossbar (1). Insert the
hardware as described in the step above.
C. Repeat the steps above to attach the Upper Crossbar (2) to the Right and Left Main Frames (6) (5) similar to the
lower Lower Crossbar (1) steps. DO NOT TIGHTEN THE HARDWARE AT THIS TIME.
A
B2
B1
C
To Next Page
Loading...
