Pg. 13V03042022
STEP 4 (Continued)
D. Make sure the cable that runs from either side of the frame is positioned between the two guide rods. Carefully pull
the guide rods toward each other, then slide the Guide Rod Bushings (10) up into the larger hole of the frame until the
slot of the bushing is resting in the frame. Next pull the bushings along with the rods away from each other so that the
bushings slide into the smaller hole of the frame, thus locking them in place. The guide rods should be parallel to one
another at this point.
E. Slide the Weight Stack Guide Rods (7) up so that the holes in the bottom of the rods align with the holes in the
bottom of the frame. Insert two M10x115mm Hex Bolts (41) with M10 Flat Washers (43) through the frame and holes
in the bottom of the rods. Place M10 Flat Washers (43) and M10 Locknuts (42) onto the bolts and tighten them. Repeat
this step for the opposite side.
D.
E.
To Next Page
Loading...
