Pg. 12 V03042022
STEP 4
A. Thread the Weight Stack Pulley (14) into the top of both the Top Plate Assembly (8), leave about a ¼ inch of thread.
B. Insert the Weight Stack Guide Rods (7) through the holes in the bottom of the frame. Be sure the ends of the rods
with the holes are facing down, and do your best to align them with the holes in the frame. Then slide one Rubber
Bumper (11) down each of the guide rods until they are resting on the bottom frame.
C. Let the Weight Stack Guide Rods (7) rest at an angle in the frame. Using the provided lubricant, spread the liquid up
and down the guide rods. Then slide on 15 Weight Stack Plates (9) with the sticker cut out facing towards the inside
of the machine and the protruding pads on the weights facing downward. Next slide on the Top Plate Assembly (8)
assembly. Slide on the Guide Rod Bushings (10), one on each rod, the tapered end of the bushing points downward.
Repeat this step for the opposite side.
A. B.
C.
To Next Page
Loading...
