Pg. 15V03042022
STEP 6
Bolt the smith bar hooks to each side of the main frames. The Right Smith Bar Hook (35) is the mount with the locking
pin, the Left Smith Bar Hook (36) is the mount without the pin. Use three M8x20 Buttonhead Cap Screws (44) with
M8 Washers (45) per hook to attach to them to the frame as shown.
STEP 7
Install the Outer Right Plastic Cover (18), and Inner Right Plastic Cover (19) as shown. Carefully align and press on the
covers until they clip into place. Repeat this step with the Outer Left Plastic Cover (21) and Inner Left Plastic Cover (20).
Right Side Left Side
Securely lock the Smith Bar in the storage position
whenever it is not in use. Be sure to use the lock pin.
To Next Page
Loading...
