Pg. 16 V03042022
STEP 8
There are three dierent widths of weight stack shrouds. The widest Shroud (17) is placed on the outside facing part of
the weight stack, the Medium (17) and Narrow (17) width shrouds are placed together on the inside, with the smaller
placed toward the back of the machine. The mounting plates for them will be marked identifying the Top Shroud Plate
(15), Bottom Shroud Plate (16) and the forward direction of them, slide the plates through the pockets of the shrouds.
Before applying the inner shrouds, apply the weight plate stickers. The number 1 sticker will go on the top plate, but we
recommend that you start with the number 2 sticker. Place the number two sticker on the rst weight plate. Then, apply
the number 1 to the top weight plate assembly, using the #2 sticker to align it properly. Finish applying the stickers through
16. Secure the weight shrouds with M8 x 20mm Button Head Cap Screw (44) with M8 Washers (45) through the
mount plates to the frame.
To Next Page
Loading...
