Pg. 17V03042022
STEP 9
A. Place the Accessory Rack (31) on right side of the Upper Crossbar (2). Insert two M10 x 75mm Hex Bolts (39) with M10
Flat Washers (43) through the rack and crossbar. Place M10 Flat Washers (43) and M10 Locknuts (42) onto the bolts. Tighten
the hardware.
B. Place the 5 Lbs. Add-On Weight (23), Dual Hook Curl Bar (24), Triceps Rope (25), Chin/Dip Belt (26), and Ankle
Strap (27) on the accessory rack as shown. Note: to use the 5 lbs. Add-On Weight place them on top of the weight stacks
in between the pullies.
C. Mount the Tablet Mount (12) in the middle of the Upper Crossbar (2). Insert two M10 x 75mm Hex Bolts (39) with
M10 Flat Washers (43) through the mount and Upper Crossbar (2). Place M10 Flat Washers (43) and M10 Locknuts
(42) onto the bolts, tighten the hardware. Place the Tablet Holder on to its mount and secure with a M6x75mm Allen
Head Cap Screw (46) and M6 Locknut (49), using M6 Washers (48) on both sides. Tighten hardware until tablet holder
holds its position but can still be tilted up and down by hand. Note: The Tablet holder mount can be bolted up or down
depending on if you want the tablet holder higher or lower.
D. Place the Bench Mount (33) on the left side Upper Crossbar (2), insert one M10 x 75mm Hex Bolt (39) with a M10 Flat
Washers (43) through the mount and Upper Crossbar (2). Place one M10 Flat Washers (43) and a M10 Locknut (42) onto the bolt
and tighten the hardware.
E. Optional: If you have electronics with cords, you can use the included cable clips to route the cables along the frame of
the machine.
D.
A. B.
E.
C.
To Next Page
Loading...
