Instantel® Technical Note
Basic setup of a Micromate
®
for
Auto Call Home
™
1
Question:
How do I set up a Micromate to run the Auto Call Home function?
Answer:
The Auto Call Home function requires that the Micromate, modem, and PC are
configured before it will transfer data. Please refer to the Micromate User Manual
721U0201 section 11.4.4 and the Blastware™ User Manual 714U0201 section 4.4 for a
complete description and extended instructions.
NOTE: It is suggested that you configure the Micromate, modem, and PC in the office
before deploying in the field.
Configuring the Micromate for Auto Call Home
1 Touch the Auto Call Home short cut icon on the Micromate touch screen . This
Auto Call Home menu configures how the Micromate calls your destination
computer, assuming this function has been enabled.
NOTE: The Auto Call Home function does not support manually recorded events.
2 Enable Auto Call Home. Set Session Time Out to 30 minutes, Modem to Generic or
USB to PC, and baud rate to 115200.
For Modem connected Unit For Serial Port Connected Unit
NOTE: Session Time Out is used to exit Auto Call Home and return to monitor mode after the given time. Use this
feature to set the maximum amount of time the Micromate will NOT be in monitor mode.
© 2015 Xmark Corporation. Instantel, the Instantel logo, Blastware, Auto Call
Home, and Micromate are trademarks or registered trademarks of Stanley
Black & Decker, Inc. All other trademarks are property of their owners.
To Next Page
Need help?
General
