4. Installation of the GravitySuite Software
GravitySuite from InstroTek is provided with each CoreLok. This software is also
available on our web site at www.instrotek.com/downloads. This package will
allow you to enter information necessary to automatically calculate bulk
specific gravity with the CoreGravity software, maximum (apparent) specific
gravity with MaxGravity software, Aggregate bulk gravity, absorption and
apparent gravity with AggSpec and Porosity or Permeability with Porosity
program.
To install the GravitySuite package on Windows 95 or a higher windows
version:
1. Double click GravitySuite.exe on the USB drive or location of the
downloaded file.
2. Follow the prompts.
3. The program will install on your computer and will automatically place an
icon on your desktop.
4. Optional: You might need to use the rubber sheets for maximum specific
gravity tests. Please review the maximum gravity procedures and if
rubber sheets are required for your test, contact InstroTek. When you
receive the rubber sheets, note that a density value is written on the
corner of each sheet. Write this value in your manual for future reference.
You will enter this value into the program by first opening MaxGravity.
Weigh the rubber sheets and enter the weight in MaxGravity software.
The program will ask for the density of the rubber sheets. Enter the
password - DENSITY. Once the password is entered, enter the density
value written on the rubber sheets. If the rubber sheets are replaced, a
new density must be entered. The software will now automatically correct
for the rubber sheets.
To Next Page
Loading...
