The heated polishing barrel rotates. Can
my hair get tangled?
No. Unlike some of our competitors’ products,
the surface of the InStyler is a single piece and
totally smooth, so there is no way for your hair
to get caught.
How do I turn the InStyler on?
Check to make sure your device is plugged
in, then press the Power button. The LED bars
should light and begin flashing. Once the LED
lights become steady, the InStyler is ready to
go.
How do I get my InStyler to rotate?
Close the handle to start rotation, which will
begin automatically.
How do I get my InStyler to change it’s
rotation direction?
Close the InStyler twice quickly and the bar-
rel will automatically begin rotating in the
opposite direction. See page 3 for detailed
instructions.
What if my InStyler does not heat?
Check to make sure your InStyler Rotating Iron
is plugged in and press the Power button. The
LED bars should light and begin flashing. Once
the LED lights remain lit, the InStyler will be at
the set temperature and ready to use.
When I use my InStyler, why does the
temperature LED start to flash?
It is normal for the heat to fluctuate during
use. As long as the InStyler has been allowed
to reach full heat (steady LED) after powering
on, you can continue to use your appliance
while the LED is flashing.
How do I clean my InStyler Rotating Iron?
When cleaning your InStyler, disconnect it
from the power source and make sure it has
completely cooled. Wipe the outside surface
only with a soft, damp cloth. Be sure to wring
out excess water before applying it to the
unit. Clean more severe dirt by using a soft,
damp cloth with a mild soap. Ionic bristles
can be lightly scrubbed if necessary with a
damp cloth, to remove any built-up product.
Residual hair left in the bristles should be
removed. The barrel can be wiped down with
a soft, damp cloth. Use a mild soap if neces-
sary. Make sure the InStyler is completely dry
before plugging it into a power source.
Go to
myinstyler.com
for video tips
To Next Page
Loading...
