9
For more tips, tricks and videos visit WWW.MYINSTYLER.COM
SAFETY FIRST Using Your Thermal Guard
NOTE: It is recommended that you use your InStyler Rotating
Iron with the included Thermal Guard Training Aid, to help pre-
vent burns while you get used to this hot new styling tool.
Attaching Your Thermal Guard Training Aid
1. Before attaching the Thermal Guard, make sure the barrel
of the unit is cool to the touch.
2. To attach, snap the Thermal Guard Training Aid onto the
side of the unit, directly under the ring, below the barrel.
3. Rotate the Thermal Guard Training Aid until tabs are
snapped into the indentations on the body of the device.
4. Once the Thermal Guard is snapped in place, you can use
your InStyler as you normally would.
Removing Your Thermal Guard Training Aid
5. Before removing the Thermal Guard, make sure the barrel
is no longer hot.
6. To remove the Thermal Guard Training Aid, make sure the
barrel of the unit is cool, then fi rmly grab the guard piece.
Twist to release it and pull to remove.
NOTE: It is important to keep your InStyler Rotating Iron clean,
as hair product buildup can accumulate on the barrel and
bristles. With the unit unplugged and cool, wipe the outside
surface only with a lightly dampened cloth. Ionic bristles can be
lightly scrubbed if necessary. Make sure the InStyler is com-
pletely dry before plugging into power source. Please see page
14 of this manual for more detailed cleaning instructions.
Always allow the InStyler to cool before storing.
To Next Page
Loading...
