InStyler titanium - Curling Techniques; Volume Boost Styling

10
InStyler
®
Rotating Iron
Soft Curl (32mm Barrel) or
Spiral Curl (19mm Barrel)
1. For the curling technique, you may find it easier to remove the
Thermal Guard Training Aid while keeping in mind to be cau-
tious and avoid burning your face or scalp. (See page 6 for
Thermal Guard Training Aid removal instructions.)
2. Being careful to not burn your fingers, wrap a
section of hair around the barrel of your InStyler
from root to ends, with the barrel side facing
your scalp (see illustration).
3. Gently close the InStyler onto the section of hair.
Rotate your wrist slightly to ensure the ends
of your hair are included.
VolumeBoost
To give your hair a boost of even more
dramatic volume, you can try a tech-
niquecalled,“OnBaseStyling”
1. To begin, wrap a section of hair around
the barrel down to the root.
2. Place the InStyler barrel directly over the
root, close the unit and let the barrel ro-
tate for a few seconds. (see illustration)
3. Open the InStyler and let the hair fall
from the barrel. (see illustration) DO NOT
loosen newly styled sections with fingers
or comb until the hair is completely cool
to the touch. This technique can be used
anywhere you want an extra volume
boost.
4. Let the InStyler rotate for 5 to 10
seconds on each section of hair, then
gently open the unit letting the hair fall
from the barrel.
5. For tighter, more defined curls, you can
let your InStyler rotate for a few sec-
onds longer. Let hair cool completely
before running fingers through to
separate.