InStyler titanium - Troubleshooting and Maintenance Guidance

15
For more tips, tricks and videos visit, www.instyler.co.uk
15
WhatisthepoweroftheInStyler?
A. 220-240V, 50/60Hz and 65 Watts (32mm Barrel) or
42 Watts (19mm Barrel).
WhatifmyInStylerdoesnotheat?
A. Check to make sure your InStyler is plugged in. Press the
Power button. The LED bars should light and start flashing.
When the LED stops flashing the InStyler will be at the set
temperature and ready to use.
WhenIusemyInStyler,whydoesthetemperatureLED
starttoash?
A. It is normal for the heat to fluctuate during use. As long as the
InStyler has been allowed to reach full heat (steady LED) after
powering on, you can continue to use your InStyler while it is
flashing.
HowdoIcleanmyInStyler?
A. When cleaning your InStyler, disconnect it from the power
source and make sure it has completely cooled. Wipe the
outside surface only with a soft damp cloth. Be sure to wring
out all excess water before applying it to the InStyler. Clean
more severe dirt by using a soft, damp cloth with a mild soap.
Bristles can be lightly scrubbed if necessary with a damp
cloth to remove any built up product and any residual hair left
in the bristles should be removed. The barrel can be wiped
down with a soft, damp cloth. Use a mild soap if necessary.
Make sure the InStyler is completely dry before plugging into
any power source.