Integra FIREBOY Series - User Manual

144952_V01_QSG_FIREBOY_EN.docx 1/4
Quick Start Guide FIREBOY plus/eco Safety Bunsen Burner
This quick start guide is intended to provide a quick overview of your FIREBOY’s (FB)
key features and to offer basic instructions for getting started. For
detailed
information, please refer to the operating instructions (OI)
that can be found at
www.integra-biosciences.com in different languages.
Intended use
This is a general-purpose laboratory instrument. Any use of this instrument in a medical or IVD
setting is the sole responsibility of the user. FIREBOY plus/eco is an automatic safety Bunsen burner
for heating or flame-sterilizing suitable laboratory materials. For continuous operation the optionally
available long burner head must be used.
Safety information
Regardless of the listed safety notes, all locally applicable regulations must be observed.
1) FIREBOY may only be used by properly trained personnel under constant supervision in a
manner specified by INTEGRA Biosciences.
2) Observe the hazard warnings on the device. There is the risk of burns from the flame and the
still hot device.
3) Do not use the FIREBOY near flammable material or in explosive areas. Work only in well
ventilated areas.
4) Use only approved and tested safety gas tubing with threaded or hose connectors.
5) Firmly tighten all gas connections and verify gas tightness, e. g. with soap water.
6) Use only original INTEGRA Biosciences power supply pack or rechargeable batteries (FB plus
only).
7) Be sure to close off the gas supply before: Transport of the device, changing the nozzle, the
adapter, the gas cartridge or the battery, longer breaks, cleaning work.
8) Servicing work and repairs may only be performed by INTEGRA Biosciences or an authorized
after-sales service member.
Getting started
Set up the instrument on a planar surface according to the IQ/OQ document (PN 144953).
Supply voltage: 100 .zH 06 – 05 ,CAV 042 –
a. Burner head
b. Motion sensor (FB plus only)
c. LCD display (FB plus only)
d. GAS KNOB, to adjust the flame size
e. AIR KNOB, to adjust the flame temperature
f. MENU KNOB (FB plus) / PUSH BUTTON (FB eco), to
switch on/off, for flame ignition or extinguishing and for
menu navigation
Switch on/off:
ON: Press (f) briefly, OFF: Press (f) for 2 sec
Settings and language selection (FIREBOY plus only)
Rotate the MENU KNOB to switch between the operating modes and select them by pressing down.
Adjustable parameters are displayed on a black background. These can be changed by rotating the
MENU KNOB and confirmed by pressing.
a
c
e
d
f
b

Summary

Quick Start Guide

Intended use

General purpose laboratory instrument use and limitations for heating or flame-sterilizing.

Safety information

Important safety precautions including training, hazard warnings, ventilation, and gas connections.

Getting started

Initial setup steps, including power supply voltage and connecting components.

Settings and language selection

Configuring operating modes, language, and adjustable parameters for FIREBOY plus.

Fitting the nozzle for the gas in use

Adapters for the gas connection

Instructions for attaching and removing gas connection adapters, ensuring a secure fit.

Connecting the gas cartridge

Steps for securely connecting the gas cartridge, including safety checks and proper orientation.

Connecting a tubing

Electricity supply and connecting a switch

Connecting the device to mains power and optional foot or benchtop switches.

Operating

Details on different flame ignition methods and burning time options.

Working with liquids

Using the folding stand to incline the burner for safe handling of liquids.

Maintenance

Cleaning procedures, disinfection, and checks for tubing integrity.

Equipment Disposal

Manufacturer

Declaration of conformity

Integra FIREBOY Series Specifications

General

Brand	Integra
Model	FIREBOY Series
Category	Burner
Language	English