• Do not put your fingers and hands in
between the seat and the footrest when the
chair is reclining or when the chair is
returning back from the recline position to
sitting position. You may hurt your fingers/
hands badly.
• This Chair must be used in accordance with
the instruction provided.
• This Chair is not for professional use.
• The manufacturers of this chair, their
agents and distributors are not liable for any
damages to person(s) or property(s)
resulting from improper use of the chair.
Safety Information continued:
Note: All repairs must be done by qualified
technicians.
Caution: A sudden change in temperature from cold
to warm can cause condensation on electrical and
mechanical parts.
It is recommended that the chair be allowed to warm
up for a minimum of an hour before using to ensure
proper operation and reduce the chances of
mechanical breakdown.
Do not use the lift chair if any of the following events
occur:
• Water is accidentally spilled on the chair. This
may result in electrical shock.
• The upholstery is torn and the inside mechanism
is exposed.
• You detect any malfunction or another abnormal
condition during operation.
Use Caution if there is a power failure. Injury may
occur when power is restored unexpectedly if the
operation buttons are depressed.
Avoid using the chair during severe lightning storms.
Please switch the power OFF immediately and
disconnect the AC power cord from the electrical
outlet in the event of accidental damage or
malfunction.
Contact a professional for servicing.
Specifications:
Weight - The weight of the chair is 60 kgs (132 lb)
- The maximum weight capacity of the chair is 160
kgs (352 lb)
Power Requirements - 100~240 V 50 Hz 70 W
Note motor operation: 2 minutes is available for
continual use, allow 15 to 30 seconds between
cycling the motor.
Castors:
Your lift chair is supplied with four castors for easy
movement of chair and transferring of the user.
Ensure the rear castors are locked before using
any of the positioning functions to prevent
movement and possible injury or damage.
Assembly:
The chair is packed in four pieces consisting of the
back, the base & two armrests to make transport
and delivery easier. Assemble the chair as per the
assembly Instructions below.
Directions:
1) The back of the chair has a receiver bracket on
each side.
2) The rear of the base of the chair has a vertical
flat bar on each side.
3) To assemble the chair simply lower the back
receiver brackets onto the vertical flat bars until
they are fully seated on both sides.
4) The armrests slide onto the sides of the base.
90667, 90668 & 90669 Rise & Recline Chair User Manual
Armrest Pad
Backrest Pad
To Next Page
Loading...