Intel
®
Desktop Board D865PERL Specification Update
7. Change to Description of Section 2.9.1, Front Panel Audio
Connector/Jumper Block
Section 2.9.1, Front Panel Audio Connector/Jumper Block will change in its entirety as follows:
2.9.1 FRONT PANEL AUDIO CONNECTOR/JUMPER BLOCK
CAUTION
Do not place jumpers on this block in any configuration other than the one
described in Table 41. Other jumper configurations are not supported and could
damage the Desktop Board D865PERL.
This connector has two functions:
• With jumpers installed, the audio line out signals are routed to the back panel
audio line out connector.
• With jumpers removed, the connector provides audio line out and mic in
signals for front panel audio connectors.
Table 41 describes the two configurations of this connector/jumper block.
Table 41. Front Panel Audio Connector/Jumper Block
Jumper Setting Configuration
1
34
6
9
7
5
2
10
5 and 6
9 and 10
Front out signals if 6-channel audio (line out signals if
2-channel audio) are routed to the back panel line out
connector. The back panel audio line out connector is
shown in Figure 19 on page 60.
1
34
6
9
7
5
2
10
No jumpers
installed
Mic in and front out signals if 6-channel audio (line out
signals if 2-channel audio) are available for
connection to front panel audio connectors.
Table 28 on page 64 lists the names of the signals
available on this connector when no jumpers are
installed.
#
INTEGRATOR’S NOTE
When the jumpers are removed and this connector is used for front panel audio,
the back panel audio line out and mic in connectors are disabled.
To Next Page
Loading...
Need help?
General
