Advanced/RH Technical Product Specification •• Page 27
DRIVE OR OVERDRIVE - J6C2
Sets the CPU voltage to either standard voltage (3.3v), or OverDrive (3.6v). The Default setting is for a jumper to
connect pin 5-6 for standard voltage. Move the jumper to connect pins 4-5 to select OverDrive voltage.
RECOVERY JUMPER - J6C2
This jumper should be set to normal mode, Pins 1-2, and should only be moved when a recovery is being
performed, i.e. jumper 2-3.
To Next Page
Loading...
