Intel NUC 11 Pro Kit NUC11TNKi5 User Manual

8
NUC11TNK
User Guide – January 2021
3.0 Install and Remove System Memory
Intel® NUC 11 Pro Kits NUC11TNK have two 260-pin DDR4 SO-DIMM memory slots
Memory requirements:
• 1.2V low voltage memory
• 2133/2400/3200 MHz SO-DIMMs
• Non-ECC
Find compatible system memory modules at the Intel® Product Compatibility Tool:
• Intel® NUC 11 Pro Kit NUC11TNKi3
• Intel® NUC 11 Pro Kit NUC11TNKi5
• Intel® NUC 11 Pro Kit NUC11TNKv5
• Intel® NUC 11 Pro Kit NUC11TNKi7
• Intel® NUC 11 Pro Kit NUC11TNKv7
3.1 Install SO-DIMMs
If you plan to install just one SO-DIMM, install it in the lower memory socket.
To install the SO-DIMMs, follow these steps:
1. Observe the precautions in "Before You Begin" in Section 1.1.
2. Turn off all peripheral devices connected to the computer. Turn off the
computer and disconnect the AC power cord.
3. Align the small notch at the bottom edge of the SO-DIMM with the key in
the socket.
4. Insert the bottom edge of the SO-DIMM into the socket.
5. When the SO-DIMM is inserted, push down on the outer edge of the
SO-DIMM until the retaining clips snap into place. Make sure the clips
are firmly in place.

Intel NUC 11 Pro Kit NUC11TNKi5 Specifications

General

Brand	Intel
Model	NUC 11 Pro Kit NUC11TNKi5
Category	Computer Hardware
Language	English