Intel® NUC 8 Compute Element Product Specification
21
3.6 Power
The Intel® NUC 8 Compute Element requires a DC input from the carrier board via the connector.
The carrier board must provide the proper voltage and current as listed below:
• Voltage: 5.7-20 V DC +/-5%
• Current (RMS max): 3.0-10.6 A
• Current (Peak): 12 A
CAUTION
It is strongly recommended to make sure that the carrier board power source is disconnected
before installing or removing the Intel® NUC 8 Compute Element into the carrier board connector.
Installing or removing the Intel® NUC 8 Compute Element while a power source is connected to the
carrier board may cause damage to the Intel® NUC 8 Compute Element, operating system
corruption, create a no boot condition or result in data loss.
3.7 Mechanical
The following figures illustrate the mechanical form factor for the NUC 8 Compute Element. All
dimensions are shown in millimeters (mm).
Figure 8. Mylar Side
To Next Page
Loading...
