Intel NUC Kit NUC8i7BEH User Manual

User Guide for NUC8i7BEH, NUC8i5BEH, NUC8i3BEH
4
Installing and Removing Memory
Intel NUC Kits NUC8i7BEH, NUC8i5BEH, and NUC8i3BEH have two 260-pin DDR4 SO-DIMM sockets. Be
sure to select memory modules that meet these requirements:
• 1.2V low voltage memory
• 2400 MHz SO-DIMMs
• Non-ECC
Find compatible memory modules in the Intel Product Compatibility Tool
• NUC8i7BEH
• NUC8i5BEH
• NUC8i3BEH
NOTE
If you plan to install only one memory module, install it in the lower memory
socket.
To install memory, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer and
disconnect the power cord.
3. Remove the computer’s bottom chassis cover.
4. Align the small space at the bottom edge of the memory module with the key in the socket.
5. Insert the bottom edge of the module at a 45 degree angle into the socket (A).
6. When the module is inserted, push down on the outer edge of module until the retaining
clips snap into place (B). Make sure the clips are firmly in place (C).

Intel NUC Kit NUC8i7BEH Specifications

General

Brand	Intel
Model	NUC Kit NUC8i7BEH
Category	Desktop
Language	English