22
Use this item to set internal write to read command delay.
Active to Active Delay (tRRD)
Use this item to set row active to row active delay.
Read CAS# Precharege (tRTP)
Use this item to set read to precharge delay.
Four Active Windows Delay (tFAW)
Use this item to set four active windows delay.
► SATA Configuration
SATA Mode
The optional settings are: [Disabled]; [IDE Mode]; [AHCI Mode]; [RAID Mode].
Serial-ATA Controller 0
The optional settings are: [Disabled]; [Enhanced]; [Compatible].
Serial-ATA Controller 1
The optional settings are: [Disabled]; [Enhanced].
► USB Configuration
Legacy USB Support
The optional settings are: [Auto];[Disabled]; [Enabled].
EHCI Hand-off
The optional settings are: [Disabled]; [Enabled].
USB Hardware Delays and time-out
Use this item to set USB hardware time-out value for control, bulk, and interrupt
transfers.
Device reset time-out
Use this item to set USB mass storage device start unit command time-out.
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
► Super I/O Configuration
Wake-up by PS/2 keyboard
Use this item to enable or Disable PS/2 keyboard wake-up from S3/S4/S5.
Wake-up by PS/2 mouse
Use this item to enable or Disable PS/2 mouse wake-up from S3/S4/S5.
PWRON After PWR-Fail
The optional settings are: [Always Off]; [Always On]; [Former-Sts].
EUP Support
Use this item to enable or disable EUP support.
To Next Page
Loading...
