Intel® Server Board SE7520JR2 Base System Definitions
Revision 7.0
5
2. Base System Definitions
The following table lists the base system configurations tested for a given validation test run.
Each specific product/system software combination tested is assigned a Base System Identifier
Number. These numbers are used in the lists of supported adapters and peripherals referenced
in the following sections. Support for the listed add-in adapters and peripherals is only provided
for the base systems and operating systems on which they were tested.
The adapters and peripherals specified in this document may or may not have been tested on
all available board/riser combinations that make up the SE7520JR2 product family. However,
Intel will provide support for the adapters and peripherals listed when used within this family of
products
This table is updated when a new test run is performed and a new product/system software
combination was used.
Intel will only provide support for adapters and peripherals under the specified
base system configuration and operating systems versions with which they
were tested.
Base System
Configuration
Identifier #
Product Family
BIOS
Revision
mBMC/BMC
Firmware Revision
SR1400/SR2400 HSC
Firmware Revision
1 SE7520JR2 P03
mBMC FW 2.40
IMM BMC FW 23
SCSI 1.05
SATA 1.06
2 SE7520JR2 P07.x
mBMC FW2.40
IMM BMC FW 32
SCSI 1.06
SATA 1.08
3 SE7520JR2 P08.x
mBMC FW2.40
IMM BMC FW 46
SCSI 1.06
SATA 1.08
4 SE7520JR2 P09.x
mBMC FW2.40
IMM BMC FW 47
SCSI 1.06
SATA 1.08
5 SE7520JR2 P10
mBMC FW2.40
IMM BMC FW 49
SCSI 1.08
SATA 1.08
6 SE7520JR2 P11 mBMC FW2.40
SCSI 1.06
SATA 1.08