Intel WRTD-303N User Manual

6
Content Access Point
User Guide
7. Skip or finish the setup wizard.
Figure 8: Admin – Setup wizard
8.
Go to Device Management > Firmware Update. (See Figure 2.)
9.
Select the method of supplying the firmware file.
c. Upload the file from the local computer
d. Use a USB flash drive. For this method, format a USB flash drive (NTFS or FAT32), put the file on it,
plug it into the USB port of the device, and refresh the Device Management page. The file will appear
following “Update firmware from USB port”.
Note: The firmware update file’s extension must be “.tgz”. If the browser changed the file’s extension during
the download process, change it back to “.tgz”.
10.
Click Update and wait a couple of minutes for the upgrade to complete.

Intel WRTD-303N Specifications

General

Brand	Intel
Model	WRTD-303N
Category	Wireless Access Point
Language	English