Intelbras AMT 8000 - Page 101

101
Events of the restoration type
Sensor tamper
Zone no. Event Contact-ID Code
01 to 64 Sensor tamper restoration 383
Use the table above to carry out the Contact-ID event change command for zone
sensor tamper restoration, as described below:
912
+
Enter Enter
+ +
Zone N°
01 to 64
After entering the command, enter the event value in hexadecimal format from
000 to FFF (accepts numbers from 0 to 9 and the letters B, C, D, E and F) and press
the Enter key to conrm. If you only want to view the setting, press the Exit key and
no programming will be changed.
Events of the opening type
User Deactivation
User no. Event Contact-ID Code
01 to 97 User Deactivation 401
Use the table above to perform the Contact-ID event change command to
deactivate each registered user, as described below:
903
+
Enter Enter
+ +
User N°
01 to 97
After entering the command, enter the event value in hexadecimal format from
000 to FFF (accepts numbers from 0 to 9 and the letters B, C, D, E and F) and press
the Enter key to conrm. If you only want to view the setting, press the Exit and no
programming will be changed.
Events of the restoration type
User Activation
User no. Event Contact-ID Code
01 to 97 User Activation 401